How to Replace the Cord on a Sun Mountain Golf Umbrella (StepbyStep Guide)
Introduction
Tools you will need
Step 1: Remove the old cord
Step 2: Prepare the new cord
Step 3: Thread the new cord through the umbrella
Step 4: Tie off the new cord
Step 5: Test the new cord
Conclusion
Introduction
Golf umbrellas are an essential accessory for golfers, keeping them dry in the rain and providing shade on sunny days. However, over time, the cord that opens and closes the umbrella can become worn or break. In this guide, we will show you how to replace the cord on a Sun Mountain golf umbrella.
Tools you will need
To complete this task, you will need the following tools:
• A replacement cord
• Scissors
• Needle-nose pliers
• A lighter
Step 1: Remove the old cord
Begin by removing the old cord from the umbrella. Locate the cord lock, which is usually located near the top of the umbrella. Use the needle-nose pliers to remove the cord from the lock, pulling it out of the umbrella.
Step 2: Prepare the new cord
Measure the length of the old cord and cut a new cord to the same length. Use the lighter to melt the ends of the new cord to prevent fraying.
Step 3: Thread the new cord through the umbrella
Thread the new cord through the umbrella, starting at the top and working your way down. Use the needle-nose pliers to help guide the cord through the holes.
Step 4: Tie off the new cord
Once the new cord is in place, tie a knot at the end of the cord and pull it tight. Then, thread the cord through the cord lock and tie another knot on the other side of the lock.
Step 5: Test the new cord
Test the new cord by opening and closing the umbrella. If the cord is too loose or too tight, adjust the knots until the cord is just right.
Conclusion
Replacing the cord on a Sun Mountain golf umbrella is a simple task that can be completed in just a few steps. With the right tools and a little bit of patience, you can have your umbrella working like new again in no time.
Summary: If you own a Sun Mountain golf umbrella and the cord has become frayed or broken, don’t worry. Replacing the cord is a simple process that can be done in just a few steps. In this article, we’ll guide you through the process of replacing the cord on your Sun Mountain golf umbrella.
Step 1: Gather your tools
Before you begin, you’ll need a few tools. These include a pair of pliers, a needle, and some nylon cord. The nylon cord should be about the same thickness as the cord that came with your umbrella.
Step 2: Remove the old cord
Start by removing the old cord from your umbrella. To do this, use the pliers to grip the metal cap at the top of the umbrella. Pull the cord out of the cap and discard it.
Step 3: Thread the new cord
Take your new nylon cord and thread it through the hole in the metal cap. Tie a knot in the end of the cord to keep it from slipping back through the hole.
Step 4: Thread the cord through the umbrella
Next, thread the cord through the holes in the umbrella. You may need to use a needle to help guide the cord through the holes. Make sure the cord is pulled tight as you go.
Step 5: Tie off the cord
Once you’ve threaded the cord through all the holes, tie it off at the bottom of the umbrella. Use a knot that will hold the cord securely in place.
Step 6: Test the umbrella
Finally, test your umbrella to make sure the cord is working properly. Open and close the umbrella a few times to ensure that the cord is working smoothly.
Conclusion:
Replacing the cord on a Sun Mountain golf umbrella is a simple process that can be done in just a few steps. With a pair of pliers, a needle, and some nylon cord, you can have your umbrella working like new in no time. Just follow these steps and you’ll be back on the golf course in no time.