How to Make a Custom Umbrella Holder for Your Disc Golf Zuca

Summary:

If you enjoy playing disc golf in all types of weather, then you know how important it is to have an umbrella holder for your Zuca cart. While Zuca offers a standard accessory umbrella holder, you can also make a custom one that fits your needs and style.

1. Gather Materials

To make a custom umbrella holder, you will need a few materials: a PVC pipe (1 inch in diameter), two PVC caps, a PVC elbow joint, a PVC T-joint, a drill, a saw, and a measuring tape.

2. Measure and Cut PVC Pipe

Measure the length of your umbrella handle and add two inches to that measurement. This will be the length of your PVC pipe. Use the saw to cut the pipe to the appropriate length.

3. Drill Holes

Using the drill, make two holes on the top of the PVC pipe. The holes should be the same distance apart as the umbrella holder on your Zuca cart.

4. Attach PVC Caps and Joints

Attach a PVC cap to one end of the PVC pipe. Attach the PVC elbow joint to the other end of the pipe. Then, attach the PVC T-joint to the elbow joint.

5. Test Fit

Place your umbrella in the new holder to test the fit. Adjust the length of the PVC pipe if necessary.

6. Attach to Zuca Cart

Using the drill, attach the new umbrella holder to the Zuca cart. Use the same screws that were used for the standard accessory umbrella holder.

7. Enjoy!

You now have a custom umbrella holder for your disc golf Zuca cart that fits your needs and style.

In conclusion, making a custom umbrella holder for your disc golf Zuca cart is a simple and easy project that can be completed in under an hour. With this new accessory, you can enjoy playing disc golf in any weather condition.

If you’re an avid disc golfer, you know that the weather can sometimes be unpredictable. One minute the sun is shining, and the next minute it’s pouring rain. To keep yourself and your gear dry, you need an umbrella. But where do you put it when you’re out on the course? Luckily, it’s easy to make a custom umbrella holder for your disc golf Zuca. Here’s how:

Materials:

– PVC pipe (1 inch diameter)

– PVC elbow joint (1 inch diameter)

– PVC T-joint (1 inch diameter)

– PVC end cap (1 inch diameter)

– PVC cement

– Umbrella

Instructions:

1. Cut the PVC pipe into two equal lengths. The length will depend on how long you want the umbrella holder to be. A good length is around 6-8 inches.

2. Apply PVC cement to one end of each pipe and insert them into opposite ends of the PVC T-joint.

3. Apply PVC cement to one end of the remaining pipe and insert it into the open end of the PVC T-joint.

4. Apply PVC cement to one end of the PVC elbow joint and insert it into the open end of the remaining pipe.

5. Apply PVC cement to the open end of the PVC elbow joint and insert the PVC end cap.

6. Allow the PVC cement to dry according to the instructions on the container.

7. Insert the handle of your umbrella into the open end of the PVC elbow joint.

8. Your custom umbrella holder is now ready to attach to your disc golf Zuca.

To attach the umbrella holder to your Zuca, simply slide it onto one of the vertical support poles on the side of the cart. You can position it at any height that is comfortable for you. Now you can stay dry and comfortable no matter what the weather brings.

In conclusion, making a custom umbrella holder for your disc golf Zuca is an easy and practical project. With just a few inexpensive materials and a little bit of time, you can protect yourself and your gear from the elements while out on the course.